Ricoh FT5535 Service Manual page 192

8.4 PRESSURE ROLLER AND CLEANING ROLLER
REPLACEMENT
[C]
1. Remove the fusing unit (see "Fusing Unit Removal").
2. Remove the pressure springs and remove the lower fusing unit (4
screws).
3. Remove the lower fusing entrance guide [A] (2 screws).
4. Remove the pressure roller assembly [B].
5. Remove the fusing knob [C]
6. Replace the pressure roller [D] (2 C-rings, 2 bearings).
7. Replace the cleaning roller [E] (2 bushings).
NOTE: 1) When reinstalling the fusing entrance guide, tighten the screws
while pushing the guide plate up to the upper position (for
standard or thin paper). For thick paper, let the entrance guide
plate drop to the lowest position.
2) The standard pressure spring position is at the upper position.
FSM
CÓPIA NÃO CONTROLADA
[B]
5-45
CÓPIA NÃO CONTROLADA
[D]
[E]
[A]
A156/A160/A162