Ricoh FT5535 Service Manual page 597

– Alignment of the 2 Helical Wheels –
[B]
[C]
[F]
Front
1. Check that all belts are set correctly.
2. Align all screw holes [A] at the middle of the helical wheels at the center
of the bin guide slots [B], as shown.
3. In this condition, tighten all Allen screws [C] in the helical wheel drive
pulleys (2 Allen screws on each drive pulley).
4. In this condition, place the cut out [D] on the wheel sensor actuator under
the wheel sensor [E] then tighten the Allen screw on the wheel sensor
actuator.
5. Make sure that the gaps [F and G] between the base plates and the
pulleys are as shown in the illustration.
SM
CÓPIA NÃO CONTROLADA
[A]
[C]
A664R538.wmf
[G]
Rear
A664R540.wmf
3-45
CÓPIA NÃO CONTROLADA
REPLACEMENT AND ADJUSTMENT
[D]
[E]
G = 22.5 ± 0.5 mm
F = 1.7 ± 0.5 mm
A207/A208/A211
A664R539.img