Ricoh FT5535 Service Manual page 391

Rev. 7/95
[A]
[B]
7. Remove the wheel sensor assembly [A] (1 screw).
8. Remove the sorter board (2 screws, 2 locking supports, and 3
connectors).
9. Remove the rear transfer wheel [B] (1 E-ring).
NOTE: Be sure not to lose the pin [C] for the wheel.
10. Remove the pin [C] and bushing [D].
11. Loosen the two mounting screws [E] of the wheel drive motor [F].
12. Lift the wheel drive motor and slip off the timing belt [G].
13. Slide off the wheel drive shaft [H] and remove the exit roller [I]
and rubber belt [J].
CAUTION
Do not damage the paper sensor [K] when removing the exit roller.
14. Replace the exit roller and rubber belt, then reassemble the machine.
NOTE: a) When reinstalling the wheel sensor assembly, be sure that the
sensor does not touch the wheel.
b) When remounting the wheel drive motor, adjust the timing belt
tension. (See Timing Belt Tension Adjustment.)
A156/A160/A162
CÓPIA NÃO CONTROLADA
[D]
[H]
[G]
12-10
CÓPIA NÃO CONTROLADA
[C]
[K]
[E]
[J]
[I]
[F]
FSM