Ricoh FT5535 Service Manual page 574

STAPLER UNIT
– Conditions in which Stapling is Disabled –
1. Under the following conditions, the staple mode is disabled when the
staple key on the operation panel is pressed.
•
If there is paper in a bin before the main switch is turned on.
•
If the selected paper size does not match the stapling specifications.
•
If the paper is fed from the by-pass feed table.
2. Under the following conditions, the staple mode is canceled.
•
If paper is loaded in a bin by hand while the staple mode is selected.
•
If only one sheet is delivered to the bin.
•
If the stack, slip sheet, or interrupt modes are selected.
3. Under the following conditions, the manual stapling mode in sort mode
cannot be selected.
•
If paper is loaded in a bin by hand while the sort mode is selected.
•
If the paper size in the bin does not match the stapling specifications.
•
If only one sheet is delivered to the bin.
•
If a smaller width of paper is delivered on the bin later in "Mixed Sizes"
mode.
•
If copies already stapled are left in the bin.
A207/A208/A211
CÓPIA NÃO CONTROLADA
3-22
CÓPIA NÃO CONTROLADA
SM