Ricoh FT5535 Service Manual page 590

REPLACEMENT AND ADJUSTMENT
15.6 GRIP ASSEMBLY REMOVAL, AND GRIP SOLENOID,
AND GRIP POSITIONING SOLENOID ADJUSTMENT
[A]
[C]
– Grip assembly removal –
1. Open the front cover then remove the front inner cover. (Refer to Exterior
Cover Removal.)
2. Remove the grip assembly [A] (4 connectors, 3 screws).
3. Replace the grip solenoid [B] and the grip arm positioning solenoid [C].
Note: Mark the original positions of the plungers first (see below).
– Grip solenoid [B] and the grip arm positioning solenoid [C]
adjustments –
It is impossible to perform the fine positioning adjustments for these
solenoids because the magnets in both solenoids pull the plunger very
strongly.
So, mark the original position of the solenoids before removing the solenoid.
Then place the solenoid at the original position by referring to the mark you
made [D] and tighten the screws (4 screws for the grip solenoid and 3 screws
for the grip arm positioning solenoid).
A207/A208/A211
CÓPIA NÃO CONTROLADA
[B]
A664R517.wmf
[D]
3-38
CÓPIA NÃO CONTROLADA
[B]
[D]
[C]
A664R518.wmf
SM