Paper Feed And Registration; Overview - Ricoh FT5535 Service Manual

PAPER FEED AND REGISTRATION

9. PAPER FEED AND REGISTRATION

9.1 OVERVIEW

- A204/206/207/208/210/211 -
[B]
All of the above-mentioned models use the FRR system.
This model has three paper feed stations: the large capacity tray feed station
[A] (LCT machines only), the upper paper tray feed station (non-duplex
machines only), and the lower paper tray feed station [B].
The LCT holds 1,000 sheets of paper. The upper and lower paper trays are
drawer trays that hold 500 sheets of paper.
Paper can also be fed using the by-pass feed table [C], which uses the feed
mechanism of the LCT feed station. The by-pass feed table can hold 40
sheets of paper. All feed stations use the FRR feed system.
The top sheet of paper separates from the stack and is fed to the relay
rollers, then to the registration rollers.
There are two relay sensors, one located just under each set of relay rollers.
These sensors are used for paper jam detection.
A207/A208/A211
CÓPIA NÃO CONTROLADA
1-32
CÓPIA NÃO CONTROLADA
[C]
[A]
A204D512.wmf
SM