Ricoh FT5535 Service Manual page 523

13. PREVENTIVE MAINTENANCE SCHEDULE
13.1 PM TABLE
NOTE: The amounts mentioned as the PM interval indicate the number of
copies.
Symbol key: C: Clean R: Replace L: Lubricate I: Inspect
A204/A206/A207
OPTICS
Mirrors, Lens, Reflector
Exposure Glass
Exposure Lamp
Green Filter
Scanner Guide Rails
ADS, APS sensors
Lens Block Guide Rail
Dust Filter
NOTE: After cleaning the exposure lamp and/or optics, do SP4-001, then 4-201, then 3-105.
The toner shield glass has been eliminated.
AROUND THE DRUM
Drum Charge Roller
Drum Charge Roller
Cleaner
Drum Charge Roller
Terminal
ID Sensor
Erase Lamp
Quenching Lamp
Pick-off Pawls
Pre-Transfer Lamp
DEVELOPMENT UNIT
Developer
Side Seal
Development Filter
Entrance Seal
Toner Supply Unit
SM
CÓPIA NÃO CONTROLADA
PREVENTIVE MAINTENANCE SCHEDULE
EM 120 k 240 k 360 k
C C C
C C C C
I C/I C/I C/I
C C C
C C C
C C C
C C C C
C C C
@
R R R
R R R
R R R
C C C
C C C
C C C
C R C
C C C
R R R
I I I
R R R
C C C C
C C C C
1-91
CÓPIA NÃO CONTROLADA
NOTE
Cotton pad with water, or blower
brush.
Alcohol or glass cleaner
Replace if necessary
Dry cloth
Dry cloth
Blower brush. Do SP4-201 after
cleaning the ADS sensor.
Dry cloth
Replace if necessary
Clean with the special cloth if
necessary (the cloth must be dry)
Replace with the drum charge roller
as a set.
Replace with the drum charge roller
as a set.
Blower brush. After cleaning, do
SP3-001 then SP3-112.
Dry cloth
Dry cloth
Dry cloth
Dry cloth and blower brush
Do SP2-214 after replacement.
Replace if necessary
Blower brush
A207/A208/A211