Manipulator Recovery - Epson VT Series Maintenance Manual

VT6L Maintenance 6. Firmware Update
(10) The following dialog box appears when transfer has completed. Click the <Next>
(11) The following dialog box appears after the Controller reboot.
The firmware upgrade is complete.
When you install the firmware (Ver.7.4.0.2 or later) on the Controller which the firmware
NOTE

(before Ver.7.4.0.2) has been installed, the following message is displayed.
When the message is displayed, re-install the firmware.

6.3 Manipulator Recovery

If the Manipulator becomes inoperable, use the procedures described in this section to
recover.
Controller Backup is recommended for easy recovery of the Controller operation.
NOTE

For details of Controller Backup, refer to refer to the following manual.
5. Backup and Restore.
26
button to reboot the Manipulator.
button.
VT series Maintenance Manual Rev.2
Click the <Finish>