Epson VT Series Maintenance Manual page 40

VT6L Maintenance 6. Firmware Update
(8) Firmware and data file transfer starts. It takes several minutes to complete.
(9) The following dialog box appears when transfer is completed.
(10) The following dialog box appears after the Manipulator reboot. Click the <Finish>
The firmware upgrade is completed.
Start EPSON RC+ 7.0 and restore the Controller settings.
For details of restoring the operating system, refer to "5. Backup and Restore".
NOTE

When you install the firmware (Ver.7.4.0.2 or later) on the Controller which the firmware
(before Ver.7.4.0.2) has been installed, the following message is displayed.
When the message is displayed, re-install the firmware.
28
button to reboot the Manipulator.
button.
VT series Maintenance Manual Rev.2
Click the <Next>