Epson VT Series Maintenance Manual page 67

(10) Fix the ground wire between the Arm #3 and the Arm #4.
(11) Connect the LED cable connector to the
opening of the end of Arm #2.
NOTE
You can pass the connector through the

opening easily by using the wire tie.
(12) Connect the LED cable connector to the LED
board.
(13) Fix the LED board.
(14) Fix the light guide plate.
VT series Maintenance Manual Rev.2
Cross recessed head screws: 2-M4×6
Tightening torque: 2.0 ± 0.1 N·m
Arm #3 side:
Ground wire terminal marked "ARM3" on the wire
marker.
Arm #4 side:
Ground wire terminal marked "ARM4" on the wire
marker.
Connectors: LED_CN1
Cross recessed head screws: 2-M3×6
Tightening torque: 0.45 ± 0.1 N·m
Cross recessed head screws: 2-M3×10
Tightening torque: 0.45 ± 0.1 N·m
VT6L Maintenance 8. Cable
Pass through the opening
55