Sun Microsystems SPARCstorage Library Installation And User Manual page 53

Caution – The tape library and each installed tape drive must have an unique
!
SCSI ID.
To view or change the SCSI IDs, perform the following procedures:
1. Locate the LCD and keypad on the front panel.
See Figure 3-1.
2. Press Escape until the Primary Menu is displayed.
See Chapter 4.
3. Select the Configuration Menu by pressing
4. Select Set SCSI IDs by pressing
5. Set the SCSI IDs for Drive 1 (the top tape drive), Drive 2 (the bottom tape
drive), and the tape library (LIB).
• Press either
←
• Press
• Press Enter to make the selection active, or Escape to not change anything.
Installing the SPARCstorage Library
↑
↑ ↓
or to increase or decrease the SCSI ID value.
→
or to select a drive or the tape library.
↑ ↓
or , then pressing Enter.
↓
or , then pressing Enter.
2
2-25