Sun Microsystems SPARCstorage Library Installation And User Manual page 87

The following chart describes the diagnostics available and a brief description
of each diagnostic.
Self Test
Position to Elem
Park
Move Cartridge
Scan
Scan with Range
Home Gripper
Home CHM
Cycle Pick/Place
Cycle Gripper
SPARCstorage Library Menu Functions
Performs the following tests:
- Moves the gripper to the home position (bottom or left
sideof the tape library)
- Moves the CHM along the short axis once
- Moves the CHM along the long axis once
- Moves the CHM to the home position
Moves the CHM to the tape drive or to one of the
cartridge slots. You must specify an element address for
the destination.
Moves the CHM to the park position at the top of the
tape library).
Moves a cartridge from one location to another. You
must specify an element address for the source and
destination. See Table 4-1.
Scans all elements .
Scans a range of elements.
Moves the gripper to the park position (open).
Moves the CHM to the park position, then to the
opposite end of the long axis.
Causes the CHM to take a cartridge from a specified slot
or CTS and replace it in the same slot. You must specify
the source slot (see Table 4-1) and the number of
pick/place cycles that the CHM should perform in
increments of 10 (up to 250).
Causes the gripper to open and close. You must specify
the number of cycles in increments of 10 (up to 250).
4
4-17