Sun Microsystems SPARCstorage Library Installation And User Manual page 47

5. Install the SCSI regulated terminator if the tape library is the last unit of
your configuration.
6. Connect the three-hole end of the power cord to the power receptacle on
the rear panel of the tape library, then connect the three-prong end of the
power cord to the nearest power source outlet.
7. Power on your system in the following manner:
See "Powering On the Tape Library" on page 22.
a. Power on the tape library.
b. Power on the desktop system.
c. Power on the monitor.
Installing the SPARCstorage Library
2
2-19