Sun Microsystems SPARCstorage Library Installation And User Manual page 33

2. Type touch /reconfigure.
# touch /reconfigure
This command ensures that the operating system checks for the presence of
any newly installed devices when you power on or boot your system.
Note – If you omit this step, you can still automatically configure the new
drive when the system boots by using the boot -r option.
Note – If your system is acting as a server, inform the mounted users that the
system will be going down. If your system is a stand-alone system, you should
use the halt,shutdown or init0 commands.
3. Type /usr/sbin/shutdown -y -g30 -i0 and press Return.
# /usr/sbin/shutdown -y -g30 -i0
.
.
.
.
ok
The 0 in g30 and i0 is a zero.
A message is sent notifying all users who are logged in that they have 30
seconds (-g30) before the system begins to shut down. The ok or > prompt
is displayed once the operating environment is shut down.
4. At the > or ok prompt, power off the system.
See "Powering Off Your System" on the next page.
Installing the SPARCstorage Library
2
2-5