Sun Microsystems SPARCstorage Library Installation And User Manual page 156

C
Unit Attention—Sense Key 6h
C-12
The tape library does not stack Unit Attention conditions. The tape library
reports only the last Unit Attention condition when there are two or more Unit
Attention conditions. A Unit Attention condition remains in effect for a
particular initiator until that initiator clears it.
Table C-6 lists combinations of ASC and ASCQ values for the Unit Attention
sense key (6h).
Table C-6 Unit Attention Sense Key (6h) ASC and ASCQ Values
ASC ASCQ
Byte 12 Byte 13
28h 00h
28h 89h
28h 8Dh
28h 8Eh
29h 00h
2Ah 01h
3Fh 01h
SPARCstorage Library Installation and User's Guide—June 1995
Description
The door was opened then closed.
The tape library was placed in SCSI Interface mode
after operating in one of the serial port modes.
The tape library was placed in SCSI Interface mode
after operating in LCD mode.
The tape library was placed in SCSI Interface mode
after operating in one of the sequential modes
(Sequential CTS1, Sequential CTS2, or Dual
Sequential).
A power-on, SCSI bus reset, or device reset message
occurred.
Mode parameters have been changed. Issue a MODE
SENSE (1Ah) command to determine what the new
mode parameters are.
New microcode was loaded.