Sun Microsystems SPARCstorage Library Installation And User Manual page 51

With the power switch in the off (0) position, the power cord attached to the
wall outlet, and the door closed and locked:
Press the power switch to the on position.
See Figure 2-10.
When you power on the tape library, the following events occur:
• The cooling fan begins to rotate.
• The Main Screen appears on the LCD.
• The tape drives perform their initiation tests.
• The tape library performs a 40-second, initiation test.
During this test, the tape library first engages the locking solenoid in the
front door, then the CHM does the following tests:
• Verifies its full range of motion by moving along the long axis.
• Verifies the presence of the cartridge holder by touching it.
• Reseats all cartridges by touching each of them.
• Moves to the park position.
Note – The tape library has autoranging voltage selection, so you do not need
to change the voltage setting.
If the tape library does not power on as described, check the following:
•
If the LCD is not illuminated:
• Is the power switch in the on position?
• Is the power cord inserted correctly?
• Is the fuse good?
•
If the LCD is illuminated:
• Is there an error message or error code on the LCD?
• Is the door closed and locked?
Installing the SPARCstorage Library
2
2-23