Sun Microsystems SPARCstorage Library Installation And User Manual page 75

Sequential 1, Sequential 2, or Dual Sequential Modes
Set the tape library to Sequential 1, Sequential 2, or Dual Sequential mode in
order to run the SunDiag system exerciser. If only one tape drive is installed,
only Sequential 1 mode is displayed.
1. Check to see if there are any tapes in the tape drives by checking if the
bottom LED is steadily flashing or on steadily.
If there are tapes in the tape drives, you must remove them.
If the bottom LED is flashing:
a. Open the door.
b. Push the square-shaped Eject button to the right of the LEDs on the
tape drive.
The tape unloads from the tape drive. The tape library ignores the fixed
slot in all sequential modes.
c. Close the door.
The following chart explains what each sequential mode does.
Sequential 1
Sequential 2
Dual Sequential
2. Press Escape until the Primary Menu is displayed.
3. Select the Interface Menu by pressing
4. Select the Control Mode Menu by pressing
5. Select Sequential 1, Sequential 2, or Dual Sequential mode by pressing
↑
or , then Enter.
SPARCstorage Library Menu Functions
CHM picks cartridges from the holder sequentially
and processes them in Drive 1 (the top drive)
CHM picks cartridges from the holder sequentially
and processes them in Drive 2 (the bottom drive)
CHM picks the top five cartridges for Drive 1 and
the bottom five cartridges for Drive 2.
↓ ↑
or , then Enter.
↓
or
4
↑
, then Enter.
4-5
↓