Installing The Second Tape Drive - Sun Microsystems SPARCstorage Library Installation And User Manual

6

Installing the Second Tape Drive

6-4
1. Insert the drive carrier through the open door into the empty slot with the
lever on your right-hand side.
See Figure 6-3.
2. Push the drive carrier into the slot until the alignment pin goes into the
alignment hole.
3. Push down on the lever until it closes all the way.
4. Push on the front plate of the drive to completely seat the connector.
You may have to push strongly until you feel the connection.
5. Tighten the two captive screws on each end of the drive carrier faceplate
using the screwdriver.
6. Close and lock the front door.
7. Power on the tape library and resume operation.
SPARCstorage Library Installation and User's Guide—June 1995