Sun Microsystems SPARCstorage Library Installation And User Manual page 147

Error Description
Number
22 Gripper motion timeout. The
gripper motion took longer than the
maximum allocated time. Because of
this, the current to the servo motors
is shut off.
25 Pick stall. The CHM stalled while
trying to pick a cartridge from the
tape drive.
26 Cannot open gripper. The gripper
could not open.
30 S axis does not move. The CHM
could not move along the short axis.
31 S axis failed home. The CHM could
not return to the home position
along the short axis.
36 S LM629 Failure. The tape library
could not reset the servo chip for the
short axis.
40 L axis does not move. The CHM
could not move along the long axis.
41 L axis failed home. The CHM could
not return to the home position on
the long axis.
46 L LM629 reset fail. The tape library
could not reset the servo chip on the
long axis.
Table C-1 Hardware Errors by Error Code (Continued)
Corrective Action
Reset the tape library. If this error still occurs, replace the tape
library.
Remove the cartridge from the tape drive by pressing the eject
button on the drive carrier faceplate. Reset the tape library.
Open the door and look for anything that might be obstructing the
CHM gripper. Make sure the tape library and the tape drives are
not being used by the host computer then reset the tape library. If
this error still occurs, replace the tape library.
Reset the tape library. If this error still occurs, replace the tape
library.
Reset the tape library. If this error still occurs, replace the tape
library.
Make sure the tape library and the tape drives are not being used
by the host computer then reset the tape library. If this error still
occurs, replace the SMC controller card.
Open the door. Look for anything that might be obstructing the
path of the CHM along the long axis. Make sure that the axis belt is
intact. If there are no obstructions and the belt is intact, you may
need to replace the SMC controller card. If replacing the SMC
controller card does not help, replace the tape library.
Open the door. Look for anything that might be obstructing the
path of the CHM along the long axis. Make sure that the axis belt
is intact. If there are no obstructions and the belt is intact, you may
need to replace the SMC controller card. If replacing the SMC
controller card does not help, replace the tape library.
Make sure the tape library and the tape drives are not being used
by the host computer then reset the tape library. If this error still
occurs, replace the SMC controller card.
Error Codes
C
C-3