Sun Microsystems SPARCstorage Library Installation And User Manual page 151

Not Ready—Sense Key 2h
During a Not Ready condition, the tape library returns a Check Condition
status in response to each motion command until the Not Ready condition is
removed. During this time, the sense key is set to Not Ready and the ASC and
ASCQ are set to codes specifying that the tape library is not ready. All
commands except tape motion commands, perform normally.
Table C-3 lists Not Ready sense key (2h) error conditions.
Table C-3 Not Ready Sense Key (2h) ASC and ASCQ Values
ASC
Byte 12
04h
Hardware Error—Sense Key 4h
The tape library returns a sense key of Hardware Error (4h) when a hardware-
related error occurs. After Hardware Error occurs, the tape library will not
accept motion commands. For each additional motion command, the tape
library returns the same Hardware Error. The tape library executes all other
commands normally.
Table C-4 lists Hardware Error (4h) conditions. To determine the corrective
actions for the display panel numbers, see Table C-1.
Error Codes
ASCQ Description
Byte 13
01h The tape library is performing an initialization after a reset
or the door was closed.
83h The front door is open.
84h The tape library is executing ROM boot code and cannot
execute the command
89h The tape library is in 25-pin, 9-pin, or 4-pin serial port
mode.
8Dh The tape library is in LCD Interface mode.
8Eh The tape library is in Sequential CTS1, Sequential CTS2, or
Dual Sequential modes.
C
C-7