Table of Contents
Advertisement
Proper setting
• The air nozzles facing the stacker (1)
Alignment: approx. 08:00 and 10:00 o'clock (3) supports transport to
• The air nozzles facing the sewing head (2)
Alignment: approx. 12:00 and 09:00 o'clock (4) supports the feed of
4.14.3
Fig. 38: Adjusting the air supply
(1) - Sewing material
Proper setting
The air supply to the air nozzles must be adjusted to the corresponding
thickness of the sewing material.
To adjust the air supply to the air nozzles:
1. Place the sewing material (1) on the sewing table above the air nozzles.
2. Log in as a Default Technician ( p. 111) on the control panel.
3. Test the air supply using the Input/Output Test ( p. 91) menu
The air should slightly lift the sewing material, allowing you to push
Information
If the sewing material is not pushed towards the stacker/sewing head, the
air nozzles in the tabletop need to be adjusted ( p. 45) accordingly.
4.14.4
The air nozzles in the tabletop help the sewing material to be fed properly
during the ongoing sewing process. Lifting and advancing the sewing
material towards the stacker reduces the risk of the sewing material
becoming caught.
46
the stacker.
material to the sewing head during the sewing process.
Adjusting the air supply
item.
the sewing material towards the sewing head/stacker using merely
2 fingers/almost automatically.
Adjusting the air supply intensity
①
Operating Instructions 1280-7/1281-7 - 00.0 - 01/2023
Operation
Advertisement
Table of Contents
