Information
You can use the program parameters on the control panel ( p. 123,
7.8 Swing out device) to program the pneumatic stamp.
Fig. 49: Pneumatic swing out device with stamp (2)
(3) - Slot
(4) - Holder
(5) - Stamp
Stamp position distance
The distance of stamps (5) and (7) can be set individually as needed and
to match the size of the sewing material.
To adjust the stamp positions:
1. Loosen screw (6) and/or screw (8).
2. Slide stamp (5) and/or stamp (7) to the desired position in their respec-
3. Tighten screw (6) and/or screw (8).
Important
The pneumatic hose (9) must have enough play to keep it from being torn
off during the swiveling process.
56
③
④
tive slot (3).
⑤
(6) - Screw
(7) - Stamp
(8) - Screw
(9) - Pneumatic hose
Operating Instructions 1280-7/1281-7 - 00.0 - 01/2023
Operation
⑨
⑧
⑦
⑥