Beisler 1280-7 Operating Instructions Manual page 204

Error, warning and information messages
Group Number
Error 1000
Error 1001
Error 1002
Error 1004
Error 1005
Error 1006
Error 1008
Error 1011
Error 1052
Error 1053
Error 1054
Error 1055
Error 1058
Error 1120
Error 1310
Error 1320
202
Description
Sewing motor encoder plug X5B
(Sub-D, 9-pin) not connected
Sewing motor error
Sewing motor plug (AMP) not
connected
Sewing motor insulation error
Incorrect sewing motor direction of
rotation
Motor blocked
Maximum speed exceeded
Sewing motor encoder error
Encoder Z pulse missing
Sewing motor overcurrent,
internal current rise > 25A
Sewing motor overcurrent
Internal short circuit
Sewing motor overload
Sewing motor speed not achieved
Sewing motor initialisation error
Sewing motor communication error
Sewing motor general
Corrective
• Connect encoder cable to the control,
use correct connection
• Check connection and plug in, if necessary
• Test sewing motor phases (R= 2.8Ohm,
high impedance to PE)
• Replace sewing motor
• Replace the control
• Check motor phase and PE for low-impedance
connection
• Replace sewing motor
• Replace sewing motor
• Check motor plug assignment and change it
if necessary
• Check wiring in machine distributor and
change it, if necessary
• Measure motor phases and check for value
• Remedy creep in the sewing machine
• Replace sewing motor
• Carry out a reset
• Check machine class
• Replace sewing motor
• Switch off the control. Turn handwheel and
switch on the control again.
• If error is not corrected, replace sewing
motor.
• Replace the control
• Replace the control
• Replace the control
• Remedy creep in the machine
• Replace sewing motor
• Remedy creep in the machine
• Update software
• Replace the control
• Replace sewing motor
• Update software
• Replace the control
• Update software
• Replace the control
• Update software
• Replace the control
• Replace sewing motor
Operating Instructions 1280-7/1281-7 - 00.0 - 01/2023
Troubleshooting