Beisler 1280-7 Operating Instructions Manual page 102

Selection
1.3.4
Stacker/
down holder/
roll-out
device
Adjusting the
parameters for opti-
mum functioning of
the stacker and the
down holder.
100
Setting 1
1.3.3.4
Distance until the start
of suction for the chain
cut at the end of the
seam
The seam section up to the begin-
ning of the suction for the chain cut
at the seam end influences the
safe thread chain cutting.
1.3.3.5
Seam section with suction
for the chain cut
The seam section with the suction
for the chain cut at the seam
beginning ensures a clean, short
chain at the material beginning.
1.3.4.1
Down holder lift delay
after...
The delay for lifting the down
holder after the stacker has
clamped the material is used to
transfer the material into the
stacker without sliding off from
the tabletop.
1.3.4.2
Time until swing out
device swings back
Waiting time until the swing out
device swings back - after
sewing stop. This time is helpful
when reloading sewing pieces
for which the swing out device is
to stop at the sewing head.
Operating Instructions 1280-7/1281-7 - 00.0 - 01/2023
Programming Commander Pro
Setting 2
Default: 1.00 cm
Value range: 0.0-10.0 cm
Default: 2.00 cm
Value range: 0.0-10.0 cm
Default: 0.30 Sec.
Value range: 0.10-3.00 Sec.
Default: 1.00 Sec.
Value range: 0.00- 5.00 Sec.