Beisler 1280-7 Operating Instructions Manual page 206

Group Number
Error 3132
Information 3150
Warning 3151
Warning 3210
Warning 3211
Warning 3212
Error 5950
Error 5951
Error 6353
Error 6354
Information 6360
Information 6361
Information 6362
Information 6363
Information 6364
Information 6365
204
Description
Overload U60V
Maintenance required
Maintenance required
Thread breakage on Monitor 1
Thread breakage on Monitor 2
Thread breakage on Monitor 3
Flash memory error
Error No SD card
Communication failure
internal EEprom
Communication failure
external EEprom
No valid data on external EEprom
No external EEprom
connected
No valid data on internal EEprom
No valid data on internal and external
EEprom
(emergency operating features only)
No valid data on internal EEprom and
external EEprom not connected
(emergency operating features only)
Internal EEprom defective
Corrective
• Update software
• One or several stepper motors defective
• Replace the control
• Information on lubricating the machine
( p. 176)
• See the machine's service manual.
• Service is urgently required ( p. 173)
• See the machine's service manual
• The thread monitor 1 reports a thread
breakage.
Please check.
• The thread monitor 2 reports a thread
breakage.
Please check.
• The thread monitor 2 reports a thread
breakage.
Please check.
• Update software
• Replace the control
• Update software
• Replace the control
• Switch off the control unit, wait until the LEDs
have gone out, switch on the control unit.
• Switch off the control unit, wait until the LEDs
have gone out, check the machine ID connec-
tion. Switch the control unit on again.
• Update software
• Connect machine ID
• Check machine ID connection
• Switch off the control, wait until the LEDs are
off and then switch on again.
• Update software
• Check machine ID connection
• Switch off the control, wait until the LEDs are
off and then switch on again.
• Update software
• Check machine ID connection
• Switch off the control, wait until the LEDs are
off and then switch on again.
• Update software
• Replace the control
Operating Instructions 1280-7/1281-7 - 00.0 - 01/2023
Troubleshooting