Beisler 1280-7 Operating Instructions Manual page 207

Troubleshooting
Group Number
Information 6366
Information 6367
Error 7200
Error 7651
Error 7655
Error 7657
Information 7801
Information 7802
Error 8401
Error 8402
Error 8501
Error 8502
Warning 9400
Information 9400
Information 9923
Warning 9947
Information 9948
Operating Instructions 1280-7/1281-7 - 00.0 - 01/2023
Description
Internal EEprom defective and
external data not valid
(emergency operating features only)
Internal EEprom defective and
external EEprom not connected
(emergency operating features only)
CAN internal communication error
UART control panel interface
communication error
UART control panel interface buffer
error
UART control panel interface
hardware error
Software version error
Software update error
Watchdog
Internal error
Software protection
Parameter versions not compatible
Start photocell is occupied
Photocell covered
Control panel software is not updated • Update the software of the control panel
Machine shuts down!
You have reached your number!
Corrective
• Replace the control
• Replace the control
• Software update
• Replace the control
• Software update
• Replace the control
• Software update
• Replace the control
• Software update
• Replace the control
• Software update
• Replace the control
• Repeat software update
• Replace the control
• Perform a software update on the control unit
• Replace the control
• Perform a software update on the control unit
• Replace the control
• The DA tool must always be used for the
software update.
• Software update
• Release the start photocell
• Remove material
• Check photocell
• Check power supply
• Switch on the machine
• You have reached your desired number -
please enter a new value for the piece counter.
205