Beisler 1280-7 Operating Instructions Manual page 139

Programming Commander Pro
Symbol/parameter
7.21
Transport station
Attached to the transport station are the puller
at the front and the roll-out device at the rear.
Transport station ON = lowering
Transport station OFF = lifting
If you want the transport station to lower only
after .... cm, you must first set the transport
station to ON. After that, you must enter the
seam length in the parameter 7.12.1 after
which the transport station is to supposed to
move up.
Value range: ON/OFF
7.22
Laser marking lamp
The laser marking lamp indicates the position of the seam.
Value range: ON/OFF
Operating Instructions 1280-7/1281-7 - 00.0 - 01/2023
Submenu/setting
7.21.1 Seam length in cm until the transport
station is to be lowered
Default: 0 cm
Value range: 0-40cm
7.21.2 Delay until transport station moves up
Default: 0 Sec.
Value range: 0-3.00 Sec.
137