Beisler 1280-7 Operating Instructions Manual page 132

Symbol/parameter
7.7
Down holder/stamp
Activate/deactivate the down holder at the end of the seam to hold the sewing material during chain cutting.
Value range: ON/OFF
7.8
Swing out device
Setting the parameters for the swing out
device. This device is used to swivel short or
long sewing pieces closer to the stacker posi-
tion to ensure a safe stacking process.
Value range: ON/OFF
130
Submenu/setting
7.6.7
Length until contour moves in front
Length until contour moves in front; for contour guide Mode 1 and 3
Value range: 0-50 cm
7.8.2
Seam length in cm until
the stacking device swings out
Default: 15 cm
Value range: 1-30cm
7.8.3
Time in seconds until the swing out device
swings back to its base position.
Default: 0.20 Sec.
Value range: 0.00-2.00 Sec.
7.8.4
Swing out device position next to the sewing head
Here you select the position of the swing out device.
ON means that the swing out device is placed next to the sewing
head before the sewing start.
OFF means that the swing out device is positioned to the left of
the stacker before the sewing start.
Value range: ON/OFF
Operating Instructions 1280-7/1281-7 - 00.0 - 01/2023
Programming Commander Pro