Beisler 1280-7 Operating Instructions Manual page 205

Troubleshooting
Group Number
Error 2114
Error 2152
Error 2156
Error 2214
Error 2252
Error 2256
Error 2314
Error 2352
Error 2356
Error 2914
Error 3100
Error 3101
Error 3102
Information 3103
Warning 3104
Error 3105
Error 3106
Information 3107
Information 3108
Error 3131
Operating Instructions 1280-7/1281-7 - 00.0 - 01/2023
Description
Stepper motor X Functional error
Stepper motor X Overcurrent
Stepper motor X Overtemperature
Stepper motor Y Functional error
Stepper motor Y Overcurrent
Stepper motor Y Overtemperature
Stepper motor Z Functional error
Stepper motor Z Overcurrent
Stepper motor Z Overtemperature
Stepper motor calculation error
AC-RDY timeout,
DC link voltage has not reached
the defined threshold.
High voltage error,
mains voltage > 290V for a long time.
nd
Low voltage error (2 threshold)
(mains voltage < 150V AC)
st
Low voltage warning (1 threshold)
(mains voltage < 180V AC)
Pedal is not in
position 0
U24V short circuit
U24V (I²T) overload
Foot pedal not connected
Speed limited due to insufficient
mains voltage
U60V short circuit
Corrective
• Update software
• Check the stepper motor
• Replace the control
• Update software
• Check the stepper motor
• Update software
• Check the stepper motor
• Update software
• Check the stepper motor
• Replace the control
• Update software
• Check the stepper motor
• Update software
• Check the stepper motor
• Update software
• Check the stepper motor
• Replace the control
• Update software
• Check the stepper motor
• Update software
• Check the stepper motor
• Update software
• Check mains voltage
• If mains voltage is OK, replace control unit.
• Check mains voltage
• Stabilize the mains voltage
• Check mains voltage
• Stabilize the mains voltage
• Check mains voltage
• Stabilize the mains voltage
• Take your foot off the pedal when switching
on the controller
• Check the pedal setting
• Disconnect 37-pin plug, if error 3105
persists, replace control unit.
• Test inputs/outputs for 24V short circuit
• One or more of the magnets defective
• Connect pedal to enable starts by foot pedal
and intermediate stops.
• Check mains voltage
• Update software
• One or several stepper motors defective
• Replace the control
203