Beisler 1280-7 Operating Instructions Manual page 130

Symbol/parameter
7.4
Table blowing
Setting the parameters for the table air nozzles,
for lifting and transporting the material towards
the stacker during sewing. It reduces the dan-
ger of the material getting caught
Value range: ON/OFF
7.6
Contour guide
Setting the parameters for the contour guide.
In case of seam thickness, the contour guide
can be raised within the seam section to pre-
vent material blockage at the thicker point.
Value range: ON/OFF
128
Submenu/setting
7.4.2
Seam length until table blowing is switched on.
Seam length in cm until table blowing is switched on
Default: 2 cm
Value range: 0-30 cm
7.4.3
Seam length with table blowing
Seam length in cm with table air nozzles switched on
Value range: 1-250 cm
7.4.4
Duration of table blowing after seam end
Enter the time/duration for table blowing at the end of the seam to
ensure that the sewing material is transported towards the stacker
and does not get stuck on the table.
Default: 100 cm
Value range: 0-500 cm
7.6.2
Seam length until the contour guide is lowered at
the beginning of the seam
Seam length in cm until the contour guide is lowered at the begin-
ning of the seam.
Default: 1
Value range: 1-10 cm
7.6.3
Seam length until contour guide lifts
Seam length in cm until the contour guide rises to sew over
a seam thickness within the seam.
Value range: 0-100 cm
7.6.4
Seam length with contour guide up
Seam length in cm with raised contour guide for the seam thick-
ening area.
Value range: 0-20 cm
Operating Instructions 1280-7/1281-7 - 00.0 - 01/2023
Programming Commander Pro