Start-Up; Aligning The Machine Table; Compressed-Air Connections - Beisler 1265-4 Working Instructions

Beisler GmbH
C.3
C.3.1

Aligning the machine table

After the machine has been installed at the desired location, the machi-
ne table must be aligned:
• Set machine table to required height.
• Level machine table horizontally on all sides.
Setting the table height:
1. Fig. 1: Lift machine: Connect lifting device at lift points (arrows) be-
low the crossmembers. If the machine is equipped with the optional
transport rollers, release brakes before lifting.
2. Loosen locating screws 2 on all table legs.
3. Pull table legs 4 out to the desired length and retighten locating
screws.
4. Tighten height adjustment locating screws 2 .
5. Lower machine onto floor.
6. Level worktable horizontally in all directions.
7. Tighten height adjustment locating screws 2 .
NOTE - Shipping braces
Before the machine is connected to the power supply sy-
stem and operated, all shipping braces must be removed.
•
•
•
C.3.2

Compressed-air connections

Fig. 2: The compressed-air connection is preinstal-
led on the machine. It comprises the following com-
ponents:
Pressure reducer 2 with manometer 4 and
•
water separator 5 ,
Pressure hose with push-in plug 3 .
•
The pressure reducer ist installed to the machine
frame.
Connecting the machine to the compressed-air
supply system:
1. Connect pressure hose plug to on-site terminal
unit.
2. Open on-site compressed-air supply.
3. Set pressure reducer to a machine operating
pressure of 6 bar by rotating pressure reducer
knob 1 and read value on manometer 4 :
• To increase pressure, rotate in the clockwise direction.
• To reduce pressure, rotate in the counterclockwise direction.

Start-up

Cut off cable ties.
Remove labels.
Remove protective film from operating panel.
Service Instructions Automatic Single-Head Serging Machine 1265-4
C-6
Fig. 1
Fig. 2