Programming Commander Pro
• The Sewing foot position (8) can be set to UP/DOWN at the
• The Needle position (9) can be set to UP/DOWN at the seam end.
To enter the seam length:
1. Set Stop in seam to ON (5).
Only if Stop in seam is switched on can the settings on the user
2. At sewing stop 1 (1), briefly press the numerical value for the Seam
If the appearing field is blue, the function is enabled.
If the appearing field is gray, the function is disabled.
3. Press and hold the active numerical value for the Seam Length per
The integrated keyboard opens.
4. Enter the desired Seam Length per seam section (2) in the active field.
5. Press Ok.
The numerical value is stored, and the display returns to the previous
6. Briefly press Soft start seam length (11).
If the appearing field is blue, the function is enabled.
If the appearing field is gray, the function is disabled.
7. Press and hold the active numerical value for the Soft start seam
The integrated keyboard opens.
8. Enter the desired Soft start seam length (11) within the spec-
9. Press Ok.
The numerical value is stored, and the display returns to the previous
10. Briefly press Soft start speed (10).
The integrated keyboard opens.
11. Enter the desired Soft start speed (11) within the specified value
12. Press Ok.
The numerical value is stored, and the display switches back.
13. Set the Sewing foot position (8) at seam end to UP(blue)/
14. Set the Needle position (9) at seam end to UP(blue)/DOWN(gray).
15. Repeat steps 1-14 for each desired seam section 1-3 (1).
16. Press on the symbol
This opens the program parameters page.
Operating Instructions 1280-7/1281-7 - 00.0 - 01/2023
seam end.
interface Stop in seam be adjusted.
Length per seam section (2).
seam section (2).
user interface.
length (11).
ified value range.
user interface.
range.
DOWN(gray).
.
149