Sungrow Logger1000B User Manual page 77

User Manual
Parameter
Feed-in stop *
Control cycle
Q-Method
Note: *Only when the control method is set to Closed-loop control, the parameter Select
energy meter is settable.
step 4 Add local power control manner
Fill in Start time and Percentage (Fixed Value of Active Power), and click Save.
- - End
Subsequent Operation
Delete local power control manner: select a local control manner that needs to be deleted,
and click Clear data.
8.3.1.4 AI Control
When using the analog signal at the AI port of the Logger1000 as the dispatching input, set
the active control mode to Analog input.
step 1 Click Power control→Active power to enter the active power interface.
step 2 Set the active control mode to Analog input.
step 3 Set AI control parameters. For specific parameter description, refer to the following table.
Description
Enable: when feed-in power is detected,
theLogger1000 will deliver start instruction to the
inverter.
Disable: when feed-in power is detected,
theLogger1000 will not deliver start instruction to the
inverter.
Note: Never turn on the Enable switch arbitrarily!
Generally, keep it in Disable state.
Time interval of delivering dispatching instructions
Parameter range: 5~60s
kW: set active power value
%: set active power percentage
8 Grid Dispatching Function
67