Afci Activation; History Data; System; Running Information - Sungrow Logger1000B User Manual

7 WEB Interface

7.8.4 AFCI Activation

step 1 Click Device→AFCI Activation to enter the corresponding interface.
step 2 Check the devices that need to self-checking, click Self-checking and then Confirm on the
pop-up window.
The status of the self-checking device must be Enable. If the self-checking status
is Disabled, you can click
step 3 The result column shows the self-checking status as Self-testing, and after 7 ~ 8 seconds,
the self-checking result will be displayed as Self-checking Failure or Self-test pass.
step 4 Click Clear Fault to bring up a dialog box showing the status of fault clearing.
- - End
7.9

History Data

Click History data→Operation Log to enter the corresponding interface.
On this interface, users can view history information.

7.10 System

7.10.1 Running Information

Click System→Run Information to enter the corresponding interface.
Information such as mobile network signal strength, WLAN, AI voltage, DI status can be
viewed.

7.10.2 System Maintenance

7.10.2.1 System upgrade
Users can upgrade Logger1000 on the Web interface.
step 1 Click System→System Maintenance to enter the corresponding interface.
step 2 Click System Upgrade, select the upgrade file, and export it to the system.
step 3 Click Upgrade on the pop-up version information window. The system enters upgrade state.
- - End
The upgrade file should be in the ".zip" format.
7.10.2.2 Log export
step 1 Click System→System Maintenance to enter the corresponding interface.
step 2 Click the button Log Export to enter the corresponding interface.
46
to set the self-checking status to Enable.
User Manual