Sungrow Logger1000B User Manual page 75

User Manual
Parameter
Adjustment ratio (%)*
Control cycle
Note: *Only when the control method is set to Closed-loop control, the parameter Select
energy meter / transformer is settable.
step 4 After finishing parameter setting, click Save to save the operation.
- - End
8.3.1.3 Local Power Control
If active dispatching instruction or dispatching target value is used as dispatching input
locally, the active control mode is set to Local power control.
step 1 Click Power control→Active power to enter the active power interface.
step 2 Set the active control mode to Local power control.
step 3 Set local dispatching parameters. For specific parameter description, refer to the following
table.
Description
If the adjustment does not reach the set target value,
increase or decrease adjustment value according to the set
adjustment ratio, so as to reach the target value.
Time interval of delivering dispatching instructions
Parameter range: 5~60s
8 Grid Dispatching Function
65