LAWO Ruby standard configuration User Manual page 43

Table of Contents

Advertisement

7. System Setup
3.
Once a valid network connection is detected, the program begins checking the "Firmware" and
"Config" status of the device - this may take a few seconds.
If either component has a new version, then start by updating the firmware and then transferring the
configuration.
Checking Firmware
7.4.2
Updating the Firmware
If a new "Firmware" version is available, then update Power Core as follows.
1.
Click on Update to start the update procedure.
The "Firmware" status message shows update in progress while the necessary data is transferred. This may
take a while.
2.
Following the transfer, Power Core restarts and during this time you will lose the network connection
("Connection Status" = NOT connected).
3.
After the restart, the program reconnects and checks the "Firmware" and "Config" statuses again.
The "Firmware" status should now be up to date and you can continue on to the configuration.
ruby standard configuration User Manual
Firmware Up to Date
Version: 6.4.0/2
43/179

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Ruby standard configuration and is the answer not in the manual?

Table of Contents