Kyocera TASKalfa 306ci Service Manual page 94

U246 Finisher adjustment
(Message: Adj Fin)
Contents
Execute adjustment for the finisher installation.
Purpose
Front/rear width adjuster home position adjustment
Adjust when the consistency of the side registration guides and paper is not good and paper jam
occurs.
Front/rear staple home position adjustment
Adjust if the staple is not centered on the paper in the staple mode.
Method
1.Press the [Start] key.
2.Select [Finisher].
* :The screen for setting is displayed.
Items
Finisher
Method: Finisher
1.Select the item to set.
Items
Width Front HP
Width Tail HP
Staple HP
Setting: Width Front HP / Width Tail HP
1.Select [Width Front HP].
2.Press the [ ] [ ] keys or the numeric keys to change the counter value.
Front width adjuster home position adjust-
ment
Rear width adjuster home position adjustment -30 to 30
3.Press the [Start] key to set the setting value.
4.Press the [Stop] key to return to the screen to select the maintenance item No.
5.Enter U240 and select [Motor] and then [Width Test(A4R)].
* :The middle tray side registration guides move to A4R size position.
6.Insert paper into the side registration guides to check the consistence.
7.Repeat the above adjustment until the consistency is appropriate.
Setting the finisher adjustment value
Front width adjuster home position adjustment
Rear width adjuster home position adjustment
Front/rear staple home position adjustment
Content to adjust
Contents
Contents
Setting
range
-30 to 30
6-93
2R4/2R5/2R6
Initial setting Data varia-
tion
0 0.973mm
0 0.973mm