Kyocera TASKalfa 306ci Service Manual page 357

U464 ID correction setting
(Message: Set ID Adjustment Mode)
Contents
Set permission/prohibition of the ID correction operation (calibration). Executes each setting of
the calibration.
Purpose
Execute the calibration setting when an image failure occurs or depending on the user's request.
Execute Calibration when replacing the maintenance kit.
Method
1.Press the [Start] key.
2.Select the item to set.
* :The screen for setting is displayed.
Items
Permission
Time Interval
Mode
Leaving Time
Target Value
Calib
Setting: Permission
1.Select [On] or [Off].
Items
On
Off
* :Initial setting: On
2.Press the [Start] key to set the setting value.
Setting: Time Interval
1.By using the [+] [-] keys or the numeric keys, change the setting value.
Items
Time(sec)
*1: 40 ppm model
* :Setting is changeable in 10 count increments.
2.Press the [Start] key to set the setting value.
Permit/Prohibit Calibration
Sets the time interval to execute calibration after completing printing.
Color print mode setting
Setting the time to determine whether to execute calibration when recov-
ering from Sleep mode
Setting the target sensor value for the thick layer calibration and light
intensity calibration
Executing Calibration
Permitting Calibration
Prohibiting Calibration
Contents
Calibration interval
6-356
Contents
Contents
Setting
range
0 to 9999
2R4/2R5/2R6
Initial setting
*1
1200/900
(sec)