Kyocera TASKalfa 306ci Service Manual page 351

Setting: G
1.Select the item to set.
2.By using [Left/Right cursor] keys or the numeric keys, enter the values which are shown on the
back page of the adjustment original.
Items
L L parameter setting
a A value setting
b B value setting
3.Press the [Start] key to set the setting value.
Setting: B
1.Select the item to set.
2.By using [Left/Right cursor] keys or the numeric keys, enter the values which are shown on the
back page of the adjustment original.
Items
L L parameter setting
a A value setting
b B value setting
3.Press the [Start] key to set the setting value.
Setting: Adjust Original
* :This setting is usually unnecessary.
Items
Lead Set the adjustment value of the
leading edge.
Main Scan Sets the adjustment value of the
left edge.
Sub Scan Set the adjustment value of the
trailing edge.
1.Measure the distances "A", "B" and "C" from the upper edge of black belt 1 to the lower edge of
black belt 3 of the adjustment original.
Measurement procedure
1) Measure the distance "A", "B" and "C" between two points as follows. (A: 30mm from the
left edge, B: 105mm from the left edge, C: 180mm from the left edge)
?Measure the distance from the leading edge to the top edge of black belt 1.
2) Apply the following formula for the values obtained: ((A+B+C)/3)
2.Enter the value solved in "Lead" using the the [+] [-] keys keys.
3.Press the [Start] key to set the setting value.
4.Measure the distance "F" from the left edge to the right edge of black belt 2 on the adjustment
original.
Measurement procedure
Measure the distance "F" from the left edge at 21mm from the top edge of black belt 1to the
right edge of black belt 2.
5.Enter the values measured in "Main Scan" using the the [+] [-] keys keys.
Contents
Contents
Contents
6-350
Setting range
0.0 to 100.0 67.8
-200.0 to 200.0 -51.3
-200.0 to 200.0 48.9
Setting range
0.0 to 100.0 38.8
-200.0 to 200.0 25.3
-200.0 to 200.0 -22.8
Setting range
4.0 to 6.0 5.0
9.0 to 11.0 10.0
265.0 to 267.0 266.0
2R4/2R5/2R6
Initial Data
setting variation
-
-
-
Initial Data
setting variation
-
-
-
Initial Data
setting variation
0.1mm
0.1mm
0.1mm