Kyocera TASKalfa 306ci Service Manual page 247

U072 Adjusting the DP original center
(Message: Adjust DP Original Center)
Contents
Adjusts the DP original center line.
Purpose
Adjusted if there is a regular error between the center lines of the original and the copy image
when the DP is used
Adjustment
1.Press the [Start] key.
2.Press the [System Menu] key.
3.Place an original on the DP and press the [Start] key to make a test copy.
* :Check the duplex scanning by setting [Duplex] when test copying.
4.Press the [System Menu] key.
5.Select the item to adjust.
Items
Front
Back
CIS
6.By using the [+] [-] keys or the numeric keys, change the setting value.
For the copy example 1, increase the value.
For the copy example 2, decrease the value.
* :When the setting value is increased, the image moves to right, and it moves to left when the
setting value is decreased.
7.Press the [Start] key to set the setting value.
Precautions
Check the 2nd side after adjusting the 1st side. Adjust if necessary.
Check the copy image after the adjustment. If the image is still incorrect, adjust the following in
the maintenance mode.
U034 (P.6-228) > U065 (P.6-238) > U067 (P.6-241) > U072
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
Contents
DP center line. (Front page)
DP center line. (Back page)
Adjusts the DPCIS center line
Original
Figure 6-38
Setting range
-40 to 40
-40 to 40
-20 to 20
Copy
Copy
example 2
example 1
6-246
2R4/2R5/2R6
Initial Data
setting variation
- 0.085
mm
- 0.085
mm
- 0.085
mm