Kyocera TASKalfa 306ci Service Manual page 75

U147 Setting the toner applying mode
(Message: Set Toner Apply)
Contents
Mode selection for the operation to remove overcharged toner in the developer unit (Toner apply-
ing mode). Also, sets the operation to take toner accumulated on the developer blade back to the
developer unit (vibration motor control).
Purpose
Change the setting to reduce the toner applying amount. Execute to change the vibration motor
control frequency.
* :Density is lowered if overcharged toner stays in the developer unit.
Method
1.Press the [Start] key.
2.Select the item to set.
* :The screen for setting is displayed.
Items
Mode
Drum T7
Dev T7
Motor
Setting: Mode
1.Select the item to set.
Items
On
Off
* :Initial setting: On
2.Press the [Start] key to set the setting value.
Setting: Drum T7
1.Press the [ ] [ ] keys or the numeric keys to change the counter value.
Items
Value
2.Press the [Start] key to set the setting value.
Sets the toner applying mode.
Sets the toner applying width at the cleaning mode.
Sets the upper limit of the toner applying amount for each operation
mode.
Sets the vibration motor operation.
Sets the toner applying operation with the normal amount.
Sets the toner applying operation with less than the normal amount.
Contents
Sets the toner applying width at the
cleaning mode.
Contents
Contents
Setting range
0 to 25
6-74
2R4/2R5/2R6
Initial Data
setting varia-
tion
150 0.1mm
(Indicated as
15.0)