Kyocera TASKalfa 306ci Service Manual page 156

Setting: Cut Line: Auto
Set the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when the data is recorded in the auto reduction mode.
If the number of excess lines is below the setting, those lines are ignored. If over the setting, the
entire data on a page is further reduced so that it can be recorded on the same page.
1.Press the [ ] [ ] keys or the numeric keys to change the counter value.
Number of lines to be ignored when receiving in the auto
reduction mode.
* :Increase the setting value if a page received in the reduction mode is reduced too much with
the trailing edge margin. Decrease the value if there is dropout in received image.
2.Press the [Start] key to set the setting value.
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
Contents
6-155
2R4/2R5/2R6
Setting Initial
range setting
0 to 22 0
Data
varia-
tion
-