Kyocera TASKalfa 306ci Service Manual page 237

U059 Fan mode setting
(Message: Set Fan Mode)
Contents
Sets the conveying fan motor drive mode during paper conveying.
Purpose
A fan is added in the conveying unit so that the leading edge of paper is conveyed along with the
conveying path to prevent paper creases.
Method
1.Press the [Start] key.
2.By using the [+] [-] keys or the numeric keys, change the setting value.
Items
Interval Cycle
3.Press the [Start] key to set the setting value.
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
U061 Lamp lighting check
(Message: Check Lamp ON)
Contents
Turns the exposure lamp on.
Purpose
Light the exposure lamp to confirm.
Method
1.Press the [Start] key.
2.Select the item to operate.
Items
CCD
CIS
3.Press the [Start] key. Lamps are lit.
* :Press the [Stop] key to turn the lamp off.
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
Contents
Changes the fan control timing cycle.
Turns the exposure lamp on
Turn the CIS lamp on (when the simultaneous duplex scanning docu-
ment processor is installed)
Setting range
0 to 10000
Contents
6-236
2R4/2R5/2R6
Initial
setting
0
30/40ppm mod-
els only
Data
varia-
tion
Sheet