Kyocera TASKalfa 306ci Service Manual page 343

Method: DP FD (Chart A)
Automatic input of the target value
1.Set the specified original (P/N: 7505000107) face-up on the DP.
2.Enter maintenance item U411.
3.Select [Target].
4.Select [Auto].
5.Press the [Start] key.
6.Select [DP FD(ChartA)].
7.Press the [Start] key to read the barcode of the original chart and to start the automatic adjust-
ment.
8.When automatic adjustment has normally completed, [OK] is displayed.
* :When the error code "1e" or "1f" is displayed during the automatic adjustment in the DP
scanning and the barcode is not read, adjust the following after manually inputting the target
value.
Manual input of the target value
1.Enter the target values which are shown on the lower part of the front page of the adjustment
original (P/N: 7505000107) by executing the maintenance mode U425.
2.Set the specified original (P/N: 7505000107) face-up on the DP.
3.Enter maintenance item U411.
4.Select [Target].
5.Select [U425].
6.Press the [Start] key.
7.Select [DP FU(ChartA)].
8.Press the [Start] key to start Auto adjustment.
9.When automatic adjustment has normally completed, [OK] is displayed.
Method: DP Auto Adj
1.Set A4/Letter paper.
2.Press the [Start] key to print the adjustment original.
3.Set the adjustment original output on the table and press the [Start] key.
4.Set the output adjustment original with face-up on the DP.
5.Press the [Start] key and scan the original.
6.Press the [Start] key to start the 1st side automatic adjustment.
7.Set the output adjustment original with face-up on the DP.
8.Press the [Start] key and scan the original.
9.Press the [Start] key to start the 2nd side automatic adjustment.
* :When automatic adjustment has normally completed, [OK] is displayed. If an error occurs
during auto adjustment, error code "NGXX" is displayed and operation stops. In this case,
check the error and execute the automatic adjustment again.
6-342
2R4/2R5/2R6-3