Creating The Gtx Ibert Core - Xilinx IBERT ML628 Getting Started Manual

Hide thumbs Also See for IBERT ML628:

Table of Contents

X-Ref Target - Figure 1-45

Creating the GTX IBERT Core

This section provides a procedure to create a single Quad GTX IBERT core using

CORE Generator software. The procedure assumes Quad 100 and 6.5 Gb/s line rate, but

cores for any of the GTX Quads with any supported line rate can be created following the

same series of steps.

For more details on generating IBERT cores, refer to

documentation/sw_manuals/xilinx13_1/chipscope_pro_sw_cores_ug029.pdf,

UG029 - ChipScope Pro Software Cores

ML628 IBERT Getting Started Guide

UG806 (v1.0) May 20, 2011

Figure 1-45: CORE Generator - Readme

Start the CORE Generator tool from either the ISE Project Navigator window or a

command line:

From the Project Navigator window, select: Tools → Core Generator...

•

From a command line, enter: coregen

In the Core Generator window, click the New Project icon (highlighted in

www.xilinx.com

Creating the GTX IBERT Core

UG806_c1_45_041411

www.xilinx.com/support/

Figure

1-36).

Table of Contents