Table of Contents
Advertisement
Running the GTX IBERT Demonstration
Figure 1-27
GTX IBERT demonstration.
X-Ref Target - Figure 1-27
TX/RX Loopback Connections
Figure 1-27: Cable Connections for Quad 100 GTX IBERT Demonstration
Configuring the FPGA
This section describes how to configure the FPGA using the CF cards included with the
board. The FPGA can also be configured through ChipScope Pro or iMPACT software
using the .bit files which are available online (as collection rdf0116_13-1.zip) at:
To configure from the CF card:
1.
2.
3.
24
shows the ML628 board with the cable connections required for the Quad 100
http://www.xilinx.com/products/boards/ml628/reference_designs.htm
Insert the CF card labeled IBERT #2 into the CF card reader slot located on the
bottom-side (upper-right corner) of the board.
Plug the 12V output from the power adapter into connector J122.
Connect the programming cable to the host computer. Any of these cables can be used:
•
Platform Cable USB-II (DLC10)
•
Platform Cable USB (DLC9, DLC9G or DLC9LP)
www.xilinx.com
QUAD_100
ML628 IBERT Getting Started Guide
CKOUT2_N
CKOUT2_P
CKOUT1_N
CKOUT1_P
UG806_c1_27_041411
UG806 (v1.0) May 20, 2011
Advertisement
Table of Contents
