Viewing Gth Transceiver Operation - Xilinx IBERT ML628 Getting Started Manual

Running the GTH IBERT Demonstration
9.
X-Ref Target - Figure 1-17
10. At the top of the ChipScope Pro analyzer window, click the Reset All button
X-Ref Target - Figure 1-18
11. When prompted "Are you sure you want to reset all Channels and Counters?" Click

Viewing GTH Transceiver Operation

After completing
configured and running. The status and test settings are displayed on the MGT/IBERT
Settings tab in the IBERT Console shown in
Note the line rate, TX differential output swing, and RX bit error count:
•
•
•
18
In the project panel, double-click IBERT Console
Figure 1-17: Project Panel - IBERT Console (GTH)
(Figure 1-18).
Figure 1-18: Reset All Button
Yes.
step 11 in Starting the SuperClock-2
The line rate for all four GTX transceivers is 11.18 Gps (see MGT Link Status in
Figure 1-19).
The GTX transmitter differential output swing is preset to 800 mV.
Verify that there are no bit errors. If the count is not zero, see
www.xilinx.com
(Figure 1-17).
UG806_c1_17_041411
UG806_c1_18_041411
Module, the IBERT demonstration is
Figure 1-19.
In Case of RX Bit
ML628 IBERT Getting Started Guide
UG806 (v1.0) May 20, 2011
Errors.