Setting Up The Chipscope Pro Software - Xilinx IBERT ML628 Getting Started Manual

Setting Up the ChipScope Pro Software

1.
2.
3.
X-Ref Target - Figure 1-9
Open Cable Button
4.
X-Ref Target - Figure 1-10
ML628 IBERT Getting Started Guide
UG806 (v1.0) May 20, 2011
Start the ChipScope Pro analyzer tool on the host computer and select
File → Open Project.
When the Project window opens, navigate to the directory where the ChipScope
software project files (.cpj) were extracted. Select ml628_gth.cpj and click Open.
The .cpj file loads pre-saved project settings for the demonstration including MGT/
IBERT and clock module control parameters. For more information regarding MGT/
IBERT settings, refer to www.xilinx.com/support/documentation/sw_manuals/
xilinx13_1/chipscope_pro_sw_cores_ug029.pdf, UG029 - ChipScope Pro Software Cores.
Click the Open Cable button
Figure 1-9: Open Cable Button
When the dialog opens asking to set up the core with the settings from the current
project, click Yes (Figure
Figure 1-10: Core Settings Dialog
Note:
After completing step
lanes (Figure 1-11) and error messages will begin scrolling in the status panel at the bottom of
the GUI (Figure 1-12). This is due to a limitation in this revision of the GTH IBERT core. At this
point the IBERT core is loaded and running, but the outputs of the Si5368 on the SuperClock-2
www.xilinx.com
Running the GTH IBERT Demonstration
(Figure 1-9).
1-10).
4, the IBERT Console will open and display No Link on all four
UG806_c1_09_022511
ug806_c1_10_030311
13