Viewing Gtx Transceiver Operation - Xilinx IBERT ML628 Getting Started Manual

Running the GTX IBERT Demonstration
3.
X-Ref Target - Figure 1-33
4.
X-Ref Target - Figure 1-34
5.

Viewing GTX Transceiver Operation

After completing
configured and running. The status and test settings are displayed on the MGT/IBERT
Settings tab in the IBERT Console shown in
Note the line rate, TX differential output swing, and RX bit error count:
•
•
•
28
In the project panel, double-click IBERT Console
Figure 1-33: Project Panel - IBERT Console (GTX)
At the top of the ChipScope Pro analyzer window, click the Reset All button
(Figure 1-34).
Figure 1-34: Reset All Button
When prompted "Are you sure you want to reset all Channels and Counters?" Click
Yes.
step 5 in Starting the SuperClock-2
The line rate for all four GTX transceivers is 6.5 Gps (see MGT Link Status in
Figure 1-35).
The GTX transmitter differential output swing is preset to 590 mV.
Verify that there are no bit errors.
www.xilinx.com
(Figure 1-33).
UG806_c1_17_041411
UG806_c1_34_041411
Module, the IBERT demonstration is
Figure 1-35.
ML628 IBERT Getting Started Guide
UG806 (v1.0) May 20, 2011