Xilinx IBERT ML628 Getting Started Manual page 16

Running the GTH IBERT Demonstration
X-Ref Target - Figure 1-14
Note: Perform
in this procedure (see notes included with
3.
4.
5.
6.
7.
16
Figure 1-14: Si5368 Address, Frequency and Start Button
step 3 through
Close the ChipScope application by selecting File → Exit. Do not save the changes
when prompted. Do not power down the board.
Press and release the System ACE controller reset button (SW2) on the ML628 board to
reload the GTH IBERT demonstration design.
Restart the ChipScope application and select File → Open Project.
When the Open Project window appears, select ml628_gth.cpj and click Open.
Click the Open Cable button
www.xilinx.com
The ROM address value for the
Si5368 clock multiplier is preset to 44
(174.690 MHz)
Si5358 start button
step 8 as part of the GTH IBERT workaround described previously
step 4, page 13).
(Figure 1-15).
UG806_c1_14_041411
ML628 IBERT Getting Started Guide
UG806 (v1.0) May 20, 2011